Facebook pixel Bed Raising Dark Wood | Pepperdine University | Pepperdine Community

Bed Raising Dark Wood

Dark Wood Twin Beds

The "dark wood" beds pictured below are found in Lovernich Apartments, George Page I Apartments, and Outer Road Sophomore Housing. These beds have multiple height settings which will allow the following levels of clearance space beneath the bed: 8", 11", 14", 17", 20", 23", 26", 29", 32".

TIPS: This process requires a Rubber Mallet and is best carried out in pairs. Please come to the Housing Office or connect with your RA to check out a mallet.

At its fastest, this process will take about 5 to 10 minutes to complete.

 

1. First, remove the mattress from the bed. DO NOT remove the three support planks.

If any piece of the bed is missing, please contact the Housing and Residence Life Office.

 

bed3

 

2. Some of our dark wood beds have a safety latch on all four corners (see below).

If your bed has a safety latch, slide the latch away from the bed frame before removing the rails. 

 

latch

 

3. Use the rubber mallet to loosen the railing latches from the bed posts.

Be careful to use the mallet on metal parts of the railing.

Using the mallet on the wood may damage the bed.

 

mallet1mallet2

 

4. Once loosened, lift the railings from the bed posts and move them to the desired height.

Be sure that all four railings are adjusted to the same height setting.

 

latch2

 

5. Once the bed is in place, re-latch the safety supports on all four corners (if applicable).

6. Replace the mattress.

7. You're done!

Please contact the Housing and Residence Life Office, your RA, or your RD if you should run into any issues. We are willing, ready, and able to help.